Our reconditioning process includes…

• Disassemble bed: Remove headboard/footboard, rails, sleep surfaces, printed circuit boards, caster & wheels and all labels
• Clean/Prep bed & eradicate hidden dust particles (air blow)
• Sand & Repaint completely: Bed frame, rails, sleep surfaces & motor covers
  
• Spring Sleep Surfaces: Sanitize, sand & replace all defective/rusted helicals
• Orthopedic Sleep Surfaces: Sanitize, sand & completely repaint
• Install new Tente® Caster Assemblies: Stems, Forks & Wheels
  
• Install new Plastics on siderails: Top canes, End canes & Switch housings
• Install new Switches in siderails: Head, Hi-Lo & Knee
• Test bed Communications: Entertainment, Nurse call & Bed exit
  
• Full-function test using Hill-Rom® Side Com test equipment
• PCB Controls: Clean, test, repair & final test under full motor load
  
• Motors: Test, grease drive assembly & repair/replace as necessary
• Replace all Motor Couplings & Capacitors
• Dielectric Test (high voltage insulation) & Leakage Test (leakage to ground)
  
• Electrical safety test bed to Hill-Rom® specifications
• Affix all new labels: Safety warning, Instruction & Product marketing
  
• Exclusive of permanent Hill-Rom® serial ID
• Install NEW Headboard & Footboard: Choice of color laminate